Switching between LUTs

Moderator: jsachs

Locked
tomczak
Posts: 1367
Joined: April 25th, 2009, 12:56 am
What is the make/model of your primary camera?: Fuji X-E2
Contact:

Switching between LUTs

Post by tomczak »

I borrowed XRite i1 profiler and made two monitor profiles: one with D65 and the other 'Native', which I understand will be the temperature of backlight, likely much higher than 6500K. Each produces corresponding LUT. At the end of profiling, the i1 also loads the LUT matching the last profile, and makes this profile Windows Default (which, I take it, PWP ignores since it allows to specify the monitor profile from within the programme). But it still needs LUTs, right? Otherwise the profiles are not valid.

I can switch the Monitor profile in PWP, but how do I switch/load the proper LUT corresponding to the profile?

Cheers!
Maciej Tomczak
Phototramp.com
jsachs
Posts: 4203
Joined: January 22nd, 2009, 11:03 pm

Re: Switching between LUTs

Post by jsachs »

PM-M stores the pathname of the monitor profile in the registry when you save the profile. This is the one that CLUT Loader will load on startup. To reset this registry setting you need to run PM-M again.
Jonathan Sachs
Digital Light & Color
Locked