Digital Light & Color

When I look at the print menu, I have been assuming that the bottom of the image would print first, ie, just like the paper would feed into my printer. That is not the case. The top prints first. So if I look at the print menu image and mentally rotate it so that the so it would feed into the printe...

It looks like when select the horizontal print alignment to be 'right' the print actually comes out on
the left side of the paper. Is this a quirk of my Epson 1430 printer?

As always, Many Thanks!

John P

It would be great if when I'm using the monitor/printer calibration tool that if I could hover or click on a part of the image and have a indication on the calibration curve screen as to what part of the curve that pixel corresponds to.

Thanks!

John P

I also can't seem to use the "Enable/Disable Monitor Curves" button. If I go into the "Color Management Settings" menu, the bottom setting "Monitor Curves on Startup" has a valid file name entered, but the "Enabled" check box does not let me set it to enabled....

Attached are two snips from Monitor/Printer Curves tool.. Both have 'dips' that I assume should trigger the error message, but only one does.

I'll keep playing around.

John P

I had previously read that section and I'm still puzzled (a) and also think the doc is not quite correct (b). a) when I use a printer curve I see no change in the image printed. I'll try again later today with some more extreme curves to make sure my eyes aren't folling me. b) The doc says "To ...

I'm a bit puzzled over the proper way to use the Monitor/Printer calibration tool. These are probably stupid questions, but I really want to try to get a better WYSIWYG experience. If it makes any difference, I am focused on B&W photography. What is the proper sequence for use this feature? I st...

I neglected to say it is the 2nd to last brightness tool that crashes when trying to re-open the mask tool for it.

John P

I have a repeatable problem with a PWP crashing when I try to re-open a mask from within a brightness curve tool.

I've attached the (renamed) script file and will try to upload the tiff file to the site you have previously suggested.

Thanks!

John P

I'm using the 'double histogram' mode to lighten a portion of an image. In this mode, a point on the upper (input) histogram is linked to a point on the lower (output) histogram. Is there a way to move both points simultaneously to the left or right instead of having to move the upper and lower poin...